Cautions For Operation - Jocel NY7C-7 Manual De Instrucciones

TO USE
1. Insert the plug into the suitable wall outlet.
• Insert the plug after setting the thermostat to "MIN" position and setting the power selected
switches to "O" (Off) position.
• The heater is suitable for operation on an A.C. electricity supply having the same voltage as
that show on its rating label.
2. Press the power selected switch to the "III" (High) position then turn thermostat to the "MAX"
position, at this moment, the unit begins working, when the temperature rises to what you are
satisfied with, slowly turn thermostat counter clockwise until the indicating light of the key for
power choice is out, and the room temperature thus can be kept constant. If you want to raise
or lower the room temperature, you can make another regulation: Turn the thermostat
clockwise to raise the temperature, or counter-clockwise to lower it and you can also turn the
power switch to "I" (Low) or "II" (Medium) position for different power selecting
NOTES
 The pilot lamp will be on only if the temperature is below the setting value of the thermostat.
MODEL
NY7C-7
NY7C-9
NY7C-11
 The room must be sealed in good condition, if not; it will not make good result because of
the out flux of heat.
 The outlets of the control chamber must be kept ventilate, if not, undue move of the
thermostat may occur.
3. After use, turn the power switch to the "O" (Off) position first, then turn the thermostat to the
"MIN" position, and pull out the power supply plug.

CAUTIONS FOR OPERATION

1. Never use the unit in places where are not even or unstable.
2. Do not insert and pull out the plug with wet hand, as this may cause electrical shock, Power
supply capacity should be enough.
3. The heater must only be used in the upright position. Never use when the unit is fallen over.
4. The unit should be far away with the object flammable or easy deform during uses, make sure
there is nothing flammable or easy deform object within 1 meter (36 inches).
5. Do not allow smashing the surface with rod or sharp hard tools, as this may cause deform and
get rusty because of damage of paint coat.
POWER (LOW / MEDIUM /
HIGH)
600 / 900 / 1500
800 / 1200 / 2000
1000 / 1300 / 2300
FINS
7
9
11
- 11 -
SUITABLE AREA
2
(M
)
15
20
23