Sony SU-WL500 Manual De Instalación página 13

2
Install the display onto the Base
Bracket.
 Referring to the Screw and Hook locations
diagram/table on page 21, determine the
holes of the Base Bracket for latching the
upper hooks of the Mounting Hook.
 Hold the display securely with both hands,
and gently align it on the wall.
WARNING
• Be sure that two or more persons hold the display
when carrying it.
• When carrying the display, hold it in landscape
orientation, and take care not to drop it when
installing. Do not apply excessive force to the
display; otherwise, it may be deformed.
Mounting Hook
3
Firmly secure the display and
the Base Bracket using the
screws supplied with SU-WL500
(+BVST4 × 12).
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Confirming the
completion of the
installation
Follow the instructions in the SU-WL500 instruction
manual to confirm.
Base Bracket
When removing the
display
Follow the instructions in the SU-WL500 instruction
manual to remove.
Screw
(+BVST4 × 12)
Note
WARNING
Be sure to tighten the securing screw firmly.
If you fail to do so, the display may fall when
it is pushed upward and cause injury.
13
(GB)