Sony SU-WL500 Manual De Instalación página 7

4
Adjust the angle of the
Mounting Hook with the
supplied hex key.
Perform following  and . Make sure that
screw  firmly secures the arm base of the
Mounting Hook (both left and right).
 Remove the 2 screws  from the arm base
of the Mounting Hook (both left and right)
and determine the screw holes for the angle
(20°) you plan to change to.
 Fit screw holes of the upper arm  and
lower arm  in an adequate angle, put
screws removed in step  into the holes,
then secure both arms.
FW-65BZ35F/FW-55BZ35F
Hex key
FW-49BZ35F
Notes
• Make sure that the adjusted angle of both arms are
the same.
• Make sure that both arms are screwed in securely.
CAUTION
• Be careful not to get your fingers caught while
adjusting the angle.
5
Remove the screws for the
stands from the display (FW-
65BZ35F/FW-55BZ35F only).
Since the stands are removed when you hold up
the display, be sure to hold the display securely
so that the display does not fall down.
FW-65BZ35F/FW-55BZ35F
7
(GB)