Alpine HCE-TCAM1-WRA Guía De Referencia Rápida página 4

Spare Tire Camera & Light System for Jeep Wrangler (2007-UP)
Completed Installation Image /Product Specifi cations
Spare Tire Replace Instructions
CAUTION
Need extra careful when you replace the spare tire.
Do not drop Spare Tire Camera & Light unit on hard
surface. Doing so could damage the unit.
Do not place wheel on the mounting post.
Removing the Spare Tire
1
Remove rubber cap and lug nut.
2
Remove the Spare Tire Camera & Light unit and
unplug the connector.
3
Remove the spare tire.
Installing the Spare Tire
1
Mount the spare tire back on the hub. Make sure the
mount is aligned correctly and connector coming
out of the center cap hole. Secure the spare tire by
tightening all lug nuts.
Description
Spare Tire Carrier Lug Nut
(Aluminum Wheel)
Spare Tire Carrier Lug Nut (Steel
Wheel)
2
Connect the Spare Tire Camera and Light unit.
Rubber cap
and lug nut
3
Press the connector into the slot. Use the rubber
clips on the unit to secure the cable.
4
Using wheel lock, tighten the Spare Tire Camera
and Light unit on the mount. Use threads on the unit
to adjust horizontal angle of the camera.
We recommend using a wheel lock to protect your
investment.
Description
Spare Tire Camera and Light
Wheel Lock Lug Nut
˜ 4/12
Torque Spec.
(ft-lbs)
54
72
Recommend
to use wheel
lock to add
protection.
Torque Spec.
(ft-lbs)
14