Mettler Toledo InSUS 307 Manual De Instalación página 12

en
pH Sensor InSUS307
Value at 25°C
Messgrösse bei 25°C
Slope pH 4...7
Steilheit pH 4...7
Zero point
Nullpunkt
Membrane resistance
Membranwiderstand
Response time (90% between pH 4...7)
Ansprechzeit (90% zwischen pH 4...7)
Temperature at 25°C
Temperaturmessung bei 25°C
Quality Control passed.
Qualitätsprüfung bestanden.
Sensor Quality Certificate showing factory end control data.
4 Installation
1. Unpacking
On unpacking, check the sensor for possible mechanical damage of the glass elements, the O-rings and the Vario-
Pin (VP) connector. Report any damage to your METTLER TOLEDO supplier.
2. Installation into an Eldon James bag port
a
CAUTION: Do not clean the sensor glass elements with water, solvents or any other cleaning tools!
a
CAUTION: Removal or partial destruction of the protective Kollidon
InSUS 310 pH and an InSUS 307 XSL sensor must be prevented during sensor handling!
h
NOTICE: 1" Eldon James ports are available in different polymer materials. For a leak proof sensor installation
METTLER TOLEDO offers InSUS sensors with different O-ring configurations. If in doubt please contact METTLER
TOLEDO at insus@mt.com.
Recommended port / sensor combinations are:
1" Eldon James port material
Engage™ 8402
Dowlex™ 2517
InSUS 307 and InSUS 310 Single-use pH Sensors
30 641 982 A
Serial No. 0366001
Specification
Spezifikation
-58.5 mV/pH
7.08 pH
563 MOhm
6 sec
24.9 °C
Quality Manager
Peter Rowing
Compatible InSUS pH sensor types
InSUS 307, InSUS 310
InSUS 307/S, InSUS 310/S
coating on the glass reference electrode of an
®
© 10 / 20 METTLER TOLEDO
12
Printed in Switzerland