Restore Factory Defaults; Arm Or Disarm The Alarm System For Free; Register Wireless Sensors And Rfid Tags; Register New Wireless Sensor - Eminent EM8610 Manual Del Usuario

6.16 Restore factory defaults.

Also called hard reset. This needs to be done when, for example, a new SIM card is
installed.
0000
0
System has been restored to factory
settings.
Only programmed phone numbers can restore to factory defaults. Hard reset can
also be done by pressing the anti-sabotage button on the rear 5 times within 3
seconds. After 2 beeps all sensors are removed.

6.17 Arm or Disarm the alarm system for free

To arm the system, call the number of the alarm system. Disconnect when it's ringing.
The system will call you back. Do not pick up the phone but disconnect the
connection. The alarm is armed.
To disarm the system, call the number of the alarm system and wait for the system to
terminate the connection. The alarm is deactivated.
Remark : This function will only work when the voicemail of the SIM card is disabled!

6.18 Register wireless sensors and RFID tags

6.18.1 Register new wireless sensor

Enter the password and press
The LED will turn on. Now add the sensors by triggering the sensors piece by
piece. If you hear a beep the sensor is registered to the system. If you hear 2
beeps this indicates this sensor is already registered. The first sensor you register
will be Zone 1 the second sensor Zone 2 etc.

6.18.2 Register new RFID-tags

Enter the password and press
The LED will turn on. Now add the RFID-tags piece by piece by holding the RFID
tag close to the receiver (circle left of num. pad). If you hear a beep the RFID-tag
is registered to the system. If you hear 2 beeps this indicates this RFID-tag is
already registered.
button on the control panel.
button on the control panel.
83 |
MULTILINGUAL