Inside The Motion Detector; Infrared Sensors; Anti Sabotage Button; Led On/Off - Eminent EM8610 Manual Del Usuario

88 |
MULTILINGUAL

8.2 Inside the motion detector

Remove the screw on top of the motion detector and gently remove the front and
back.
Infrared sensor

LED On/Off

Anti sabotage
button
Group setting (jumpers)

8.2.1 Infrared sensors

The infrared sensors detect the motion. These sensors need to be clean at all time.
Do no touch the sensors !

8.2.2 Anti sabotage button

If the motion detector is opened this switch will detect it and trigger the alarm.
8.2.3 LED On/Off
By switching this jumper setting you can set if the LED in front of the motion detector
will be switched "On or Off". By default this setting is turned ON (LED ON).

8.2.4 Group settings (jumpers)

Every sensor can be configured to be added to a dedicated group by setting the
jumper settings; home-group, normal group, single group or 24-hours group.
Bellow you will see an overview of the meaning and how to configure the jumper
settings for that type of zone.
Remark : Determine before pairing with the alarm system in which group the sensor
will be operational. Once the sensor is successfully paired with the system. The group
cannot be changed after pairing!
Remark: If the group of a sensor needs to be changed, all sensors need to be paired
with the alarm system once more. It is not possible to remove one single sensor from
a group ! (See chapter "Delete all wireless sensors by text message")