English
Our products are engineered to meet the highest
standards of quality, functionality and design. We hope
you thoroughly enjoy your new Braun coffeemaker.
Caution
Please read the use instructions carefully and completely
before using the appliance.
• This appliance is not intended for use by children or
persons with reduced physical or mental capabilities,
unless they are given supervision by a person
responsible for their safety. In general, we
recommend that you keep the appliance out of reach
of children.
• Before plugging into a socket, check that your voltage
corresponds with the voltage printed on the bottom of
the appliance.
• Avoid touching hot surfaces, especially the hotplate.
Never let the cord come in contact with the hotplate.
• Do not put the glass carafe on other heated surfaces
(such as stove burners, hot trays, etc.).
• Do not microwave glass carafe.
• Before you start preparing a new pot of coffee, always
allow the coffeemaker to cool down for approximately
five minutes (switch off the appliance), otherwise
steam can develop when filling the water tank with
cold water.
• Braun electric appliances meet applicable safety
standards. Repairs on electric appliances (including
cord replacement) must only be carried out by
authorized Braun service centers. Faulty, unqualified
repair work may cause accidents or injury to the user.
• This appliance was constructed to process normal
household quantities.
• Always use cold water to make coffee.
Maximum cups
10 cups (125 ml each)
Description
A
Cord/cord storage
B
Space compensator
C
Water level indicator
D
Water tank
E
Water filter cartridge
F
Water filter exchange dial
G
Swing-filter push button
H
Filter basket with drip stop
I
Hotplate
J
Green pilot light for automatic operation
K
«auto» button for activating automatic operation
L
Clock display
M
«h» button (for setting hours)
N
«min» button (for setting minutes)
O
On/off button
P
Red operating pilot light
Q
Glass carafe
I Setting into operation
Water filter benefits and installation
The water filter improves coffee flavor by significantly
reducing chlorine and calcification (lime scale) buildup.
6
Provided that the cartridge is replaced regularly (every
two months), the water filter provides better tasting
coffee and extends the life of your coffeemaker. Braun
water filter cartridges are available at your local retailer or
Braun service centers.
Installing the water filter cartridge
1. Unpack the water filter cartridge
2. Remove the space compensator
tank.
3. Insert the water filter cartridge. (Be certain to keep the
space compensator as it must be installed in the
water tank whenever the water filter cartridge is
removed.)
4. The water filter should be exchanged every two
months. To remind you, set the dial
that the water filter should be replaced.
Note: Before using the coffeemaker for the first time, after
a long period of not using it, or after installing a new water
filter cartridge, run the coffeemaker through one brewing
cycle using the maximum amount of cold, fresh water
without any ground coffee in the filter basket.
Setting the clock
After plugging in the coffeemaker, the time «00:00» will
flash on the display
L
. To set the clock, press either the
«h» or the «min» button
Then hold the button or press repeatedly until you reach
the desired time.
M
Press the «h» button
N
«min» button
to program the minutes.
Recommendation: Just before reaching the correct time,
repeatedly press the «h» or «min» button briefly to avoid
going past the desired time. The colon between the hours
and minutes will flash for five seconds indicating that the
clock has been successfully been programmed.
Note: If the power supply to the coffeemaker is
interrupted (e.g., power failure, cord is unplugged), clock
and programmed time are stored for 10 minutes.
Manual operation
To switch on, press the «on/off» button
light
P
will light up indicating that the coffeemaker is
switched on and brewing is in process. To switch off the
coffeemaker, press the «on/off» button. The red pilot light
will go off to indicate that the coffeemaker has been
switched off.
Automatic operation
To program the automatic operation, press the «auto»
K
button
until the green pilot light
The time «12:00» or the previously programmed time
appears on the display.
Then program the time for automatic operation by
pressing the «h» and «min» buttons
under «Setting the clock». After programming is
completed, the green pilot light
seconds.
To activate the automatic operation, briefly press the
«auto» button
K
. The green pilot light
E
.
B
from the water
F
to the month
M
/
N
for at least two seconds.
to program the hours. Press the
O
. The red pilot
J
begins to flash.
M
/
N
as described
J
will go off after five
J
lights up and