Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
D-Fi™ 2.4 GHz
(DMX Mode
Manual Sync)
Page 26 of 88
The Freedom™ Quad-5 series offers wireless control of 2 or more products with a single
DMX controller. To manually set up the D-Fi™ syncing function for DMX functionality, do
the following:
For the transmitting product:
1.
Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
4.
Press <UP> or <DOWN> until S-tr shows on the display.
5.
Press <ENTER>.
6.
Press <UP> or <DOWN> until dt.CH shows on the display.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select the transmitting signal (dt.01–dt.16).
For the receiving product(s):
1.
Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
4.
Press <UP> or <DOWN> until S-tr shows on the display.
5.
Press <ENTER>.
6.
Press <UP> or <DOWN> until dr.CH shows on the display.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select the receiving signal (dr.01–dr.16). The channel
number should match the transmitting signal you chose in the prior steps.
Once the steps above are done, you can then back out to a more general menu level
and configure the transmitting product to operate it with a DMX controller.
To configure your product to work with DMX, refer to the Starting Address section of the
Operation section of this manual.
·
If you are experiencing antenna issues or need to improve signal quality,
extend the antenna outward away from the product and keep the line of sight
between products unobstructed.
·
Ensure that all linked products are configured to the same DMX personality
(either 4-channel or 5-channel).
·
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing
steps.
Freedom™ Par Quad-5 and Strip Mini Quad-5 User Manual Rev. 5
Publicidad
Tabla de contenido
