D-Fi™ 2.4 Ghz (Ir/Standalone Mode Manual Sync); Mode Manual - Chauvet Freedom Par Quad-5 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

D-Fi™ 2.4 GHz
(IR/Standalone

Mode Manual

Sync)
Page 28 of 88
The Freedom™ Quad-5 series can be configured to control 2 or more products with no
external controllers or with the IRC from CHAUVET® (sold separately). To manually set
up the D-Fi™ syncing function for IR/standalone functionality, do the following:
For the transmitting product:
1.
Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2.
Use <UP> or <DOWN> to select SYS.
3.
Press <ENTER>.
4.
Press <UP> or <DOWN> until S-tr shows on the display.
5.
Press <ENTER>.
6.
Press <UP> or <DOWN> until t.CH shows on the display.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select the transmitting signal (t001–t016).
For the receiving product(s):
1.
Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2.
Use <UP> or <DOWN> to select SLAv.
3.
Press <ENTER>.
4.
Press <UP> or <DOWN> until r-St shows on the display.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select the receiving signal (r001–r016). The channel
number should match the transmitting signal you chose in the prior steps.
Once the steps above are done, you can then back out and configure the transmitting
product to operate it in either Automatic mode or with an IRC (sold separately).
To configure your product to work in automatic mode, refer to the Automatic mode
sections of the Operation section of this manual.
To configure your product to work with the CHAUVET® IRC, refer to the IRC (Infrared
Remote Control) section of the Operation section of this manual.
·
While using the D-Fi™ syncing function, the transmitting product can also be
connected to other compatible Freedom™ series products using DMX linking.
·
If you are experiencing antenna issues or need to improve signal quality,
extend the antenna outward away from the product and keep the line of sight
between products unobstructed.
·
Ensure that all linked products are configured to the same DMX personality
(either 4-channel or 5-channel).
·
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing
steps.
·
The Freedom™ series is fully compatible with the D-Fi™ 2.4 GHz wireless
transceiver (transmitter/receiver) from CHAUVET® (sold separately).
·
For more detailed information about D-Fi™ functionality, refer to the D-Fi™
2.4 GHz User Manual available at the CHAUVET® website:
www.chauvetlighting.com.
Freedom™ Par Quad-5 and Strip Mini Quad-5 User Manual Rev. 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Freedom strip mini quad-5Freedom par quad-5

Tabla de contenido