Maintenance And Storage - KRATOS SAFETY FA 60 023 20 Manual De Instrucciones

SAFETY), but it may be reduced according to use and/or the results of the annual inspections. The equipment should be inspected if there is any doubt,
or following a fall, and at least annually, by the manufacturer or a competent person and in strict compliance with the manufacturer's periodic inspection
procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check its strength and therefore the user's safety. If the WINCH is used
for load lifting, the checks are carried out every 6 months. The product data sheet should be completed (in writing) after each verification. The date of
inspection and date of the next inspection must be indicated on the data sheet. It is also recommended to put the date of the next inspection on the product.
MAINTENANCE AND STORAGE: (These instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and keep it in its packaging. Clean with water, wipe with a cloth and hang in a
ventilated room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have become wet
during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
8