LIVARNO LUX HG00731A Instrucciones De Utilización Y De Seguridad página 12

T he product is only suited for use with the included mains adapter (model no.
DCSP060050-6EU).
P lease note that the power adapter continues to draw a small amount of power
even if the lamp is turned off as long as the power adapter is plugged into a
power outlet. To switch the device off completely, unplug the power adapter
from the socket.
T he illuminant is not replaceable. If the illuminant fails at the end of its life, the
entire light must be replaced.
Before use
Q
Charging the LED work lamp
Q
Note: You can charge the LED inspection lamp
mains power outlet or from the cigarette lighter socket in your vehicle.
Note: The fuse of the car adapter is replaceable. The specification must comply
with information given in the section "Technical Data". The fuse may only be replaced
by a qualified electrician (see Fig. B).
Tip: We recommend that you charge the LED work lamp from an ordinary
domestic mains power outlet to avoid draining your vehicle's battery.
CAuTiON! Do not connect the LED work lamp to the cigarette lighter socket of
your vehicle if the vehicle battery is old or degraded. Failure to observe this advice
may result in your vehicle's engine not starting.
Note: To use the LED work lamp without an adapter, you must first charge the integral
rechargeable batteries. It takes between 7 and 8 hours to charge the integral
batteries. The rechargeable batteries are permanently installed in the base of the
LED work lamp.
Note: Charge the LED work lamp for approximately 12 hours before first use.
Note: Charge the LED work lamp at least once a month, if it is to remain
unused for an extended period of time.
Note: If the LED work lamp has not been charged for an extended period of time
(approx. 2 months), you could find that the integral rechargeable batteries have
entered a dormant state. Charge and discharge the LED work lamp a number of
times in succession to reactivate the integral rechargeable batteries.
Before charging, switch the torch
P lug the male connector of the mains adapter
the female connector
Note: When charging from a cigarette lighter socket, the adapter must al-
ways be fully inserted into the cigarette lighter socket of the vehicle. Otherwise
there is the danger of fire through overheating.
I nsert the mains adapter into a mains socket or insert the car adapter into the
cigarette lighter socket in your vehicle.
Note: The product is fitted with an overcharge protection circuit. Despite this,
you should disconnect the LED inspection lamp from the power supply after the
charging process is complete.
Note: During charging, the charge indicator LED
charging is complete, the charge indicator LED lights up green. When the
charge indicator LED is green, pull the mains adapter out of the socket or the
car adapter from the cigarette lighter socket. Disconnect the adapter from the
LED inspection light to prevent the batteries from discharging.
use
Q
CAuTiON – riSK Of ACCiDENT! If at all possible, do not use the LED
work lamp in a moving vehicle. If the LED work lamp is used in a vehicle, it must not
be allowed to endanger the safety of the driver or passengers. Always store and
secure the LED work lamp in such a way that there is no risk of injury from or dam-
age to the product, even during full braking.
Note: The LED inspection light
surface is sufficiently magnetisable to carry the weight of the light, before you use
the magnetic foot.
12 GB/IE
off (press ON / OFF switch
1
.
8
features a magnetic foot
6
from an ordinary domestic
6
or of the car adapter
4
lights up red. When
7
. Ensure the metallic
3
).
2
into
5