Fein MULTIMASTER FMM250 Manual De Instrucciones página 12

3 41 01 091 21 0.book Seite 12 Dienstag, 24. Juli 2007 3:32 15
EN
Changing the tool.
The application tool can be fastened offset at convenient working positions at 45°
steps (or at 30° steps for the triangle-shaped sanding pad).
M M FMM 250 Q (Figure 3).
ULTI ASTER
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chang-
CAUTION
ing application tools, always
wear protective gloves. Danger of injury
from the sharp edges of the application
tools. Application tools can become very
hot while working. Danger of burns!
Loosen the quick-clamping lever
and swivel it to the stop.
Pull out the fastening element.
Clean the tool holder, the applica-
tion tool and the fastening element.
Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
Insert the fastening element to the
stop into the tool holder.
Swivel the quick-clamping lever back
until it engages.
Protect your hand and fin-
CAUTION
gers from being bruised/
crushed from the snapping back quick-
clamping lever. The quick-clamping lever
pivots back powerfully due to the spring
force.
12
M M FMM 250 / M
ULTI ASTER
Fastening element
Fig. 3
Tool holder
Quick-clamping lever
M FMM 250 Q
ULTI ASTER
180°