Taking Body Composition Readings - Tanita InnerScan BC-1000plus Manual De Instrucciones

5) Once the pairing process is completed with the platform, the remote display
shows "donE" and then the clock will be displayed. If the remote display
shows " P-Err ", please try the pairing process again.
Note : To confirm the paired serial number on each personal number after completion the pairing process:
Press and hold the SET button for 2 seconds on the remote display. The remote display will show "-1-". Select the per-
sonal number using s/t buttons, and press the SET button to confirm. The display shows the paired serial number for
3 seconds. "-----" is shown if there is no serial number stored for selected personal number.
3. Setting and storing personal data in the remote display
You will receive readings only if data has been programmed into the Tanita remote display.
1) Select Personal Data Number
Use the SET button to activate the unit. Use s/t buttons to select a personal data number. Press SET button.
2) Set Age (Applicable Age: 7 - 99)
Use s/t buttons to select age. Press SET button.
3) Select Female or Male (Applicable Athlete Age: 18 - 99)
Use s/t buttons to select Female / Male / Athlete Female / Athlete Male. Press SET button.
4) Specify Height
Use s/t buttons to select height. Press SET button.
5) Select Activity Level (Except D-1100 plus)
Use the s/t buttons to specify Activity Level. Press the SET button to confirm.
The remote display will beep twice and the display will flash all data three times to confirm the programming.
The display will turn to the clock.

4. Taking body composition readings

1) Before proceeding, make sure that the platform and remote display are within 17 feet (5 m) of each other.
2) Press t (User) button to turn the unit on and then press s/t buttons to select personal data number.
(Do not stand on the platform.)
3) Press the SET button to confirm your personal number.
4) When the remote display and platform are paired, the platform will beep once, and the Green Indicator Light on
the platform will blink.
5) Step onto the platform while the Green Indicator Light is blinking.
6) After the measurement is complete, the platform will beep twice, readings will automatically show on the
remote display (Refer to fig. 2).
7) Carefully step off platform after measurement is complete.
8) At anytime during and after the "Auto Display Process", the user may use s/t buttons to scroll through the
different results. For advanced scrolling, the user may press and hold s/t button.
Upon reading the desired readings, release the button to view the result, readings will appear for 30 seconds
before the unit automatically shuts off.
Note: For children (age 7-17), the unit will only display the Weight and the Body Fat % (it will not display the Healthy Range
Indicator).
5