Installing The Noise Reduction Baffle System; Items Supplied; Tools Required; Installing The Stowage Straps - Wilderness Systems Helix PD El Manual Del Propietario

6. INSTALLING THE NOISE REDUCTION BAFFLE SYSTEM

6.1 Items Supplied

• (2) Fiber Brush Baffles (D)
• (8) 10-32x 3/8" Screws (included with Helix PD kayak)
6.2 Tools Required (not supplied)
• #2 Phillips Head Screw Driver
6.3 Installing the Noise Reduction Baffle System
Turn over your Helix PD kayak so the hull bottom is exposed. Locate the 8 insert locations surrounding the Helix PD scupper
area of the kayak. Remove the filler screws included with the Helix PD kayak from the inserts.
Place the baffles (D) into the stepped recess of the scupper. The face of baffle plate (D) that has the step on it aligns with the
detent in the scupper molded into the hull of the kayak.
Use the filler screws that were included with your Helix PD kayak to secure the baffles (D) to the inserts so that the fiber
brushes create a gate covering the scupper recess.
Note: The 10-32 x 3/8" Philips truss head screws required for this step were included and installed with your Helix PD kayak.

7. INSTALLING THE STOWAGE STRAPS

7.1 Items Supplied
Kit C
• Stowage Strap with Male Buckle (C)
• Stowage Strap with Female Buckle (C)
• (2) Deck Loops (C1)
• (4) 10-32 x ¾" Screws (C2)
• (4) 10 x 5/8" Neoprene Washers (C3)
• (4) 10-32 Cap Nut (C4)
7.2 Tools Required (not supplied)
• #2 Phillips Head Screw Driver
• 3/8" Wrench
• 7/32" Drill Bit
• Drill
8 Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607