Installing The Helix Pd To Your Kayak For Use; Operating The Helix Pd; Launching And Landing - Wilderness Systems Helix PD El Manual Del Propietario

10. INSTALLING THE HELIX PD TO YOUR KAYAK FOR USE

Remove the quick release pin (A6) from the mounting bracket (A). Holding the Helix PD (E) at an angle, lower the upper
housing block portion of the Helix PD (E) into the mounting bracket (A) and align the mounting bracket (A) receiver hole
with upper housing receiver hole of the Helix PD (E) and insert the quick release pin (A6) until it is fully engaged through the
receiver holes and the cotter pin hole is exposed. Secure the quick release pin (A6) with the cotter pin (A5). Pivot the Helix PD
forward into the stowed position until ready for use in the water.
Tip: Never transport your kayak with the Helix PD unit attached to it.

11. OPERATING THE HELIX PD

11.1 Launching and Landing

With the Helix PD (E) attached to your kayak and in the stowed position, launch your kayak into the water. Pull the Helix PD (E)
upwards and towards you to pivot the Helix PD (E) in to the vertical zero daft position. On each side of the Helix PD (E) and
mounting bracket (A) secure the blade of the latch base (A2) into the hook of the latch hanger (A1) and tighten the draw
latches down. To fully deploy the Helix PD (E) into the pedaling position, push the Helix PD (E) down until it locks and you hear
it click into place. You are now ready to pedal the unit.
16 Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607