Installing The Rudder Hold-Down Strap; Items Supplied - Wilderness Systems Helix PD El Manual Del Propietario

Test the rudder deployment control line assembly (B6). Pull the stern most control fitting of the rudder deployment control
line (B6) forward to deploy the rudder (B) and then pull the opposite control fitting of the rudder deployment control line (B6)
to stow the rudder (B).
Once you are satisfied with the operation of your rudder (B), trim the excess lift line from the rudder deployment control line
(B6) assembly and burn the ends to prevent fraying.
Tip: Online video instruction of this assembly and many other assemblies are available at wildernesssystems.com

8.7 Installing the Rudder Hold-Down Strap

Items needed:
• Rudder Hold-Down Strap (B7)
• J-Hook (B8)
Attach the J-hook (B8) to the bungee on the Rudder hold-down strap (B7) and tie an overhand knot to secure.
Remove the top portion of the stern handle. Remove the screws from stern handle. Remove the handle and then reattach
handle with the rudder hold-down strap (B7) positioned on the right screw between the handle and the deck of the boat.
9. INSTALLING THE STEERING CONTROL

9.1 Items Supplied

• Steering Control (J)
• Kit B
• (2) Cord Lock (B9)
• (2) ¼ x5/8" Neoprene Washer (B10)
• (2) 5/8" Split Rings (B11)
• (2) 10-32 x 5/16" Set Screw (B12)
9.2 Tools Required (not supplied)
• Phillips Head Screw Driver
• 3/32" Allen Wrench
Wilderness Systems, 575 Mauldin Road, Suite 200, Greenville, SC 29607 13