Ryobi RBL26BP Manual De Utilización página 21

STARTING AND STOPPING
WARNING
Never start or run the engine inside a closed or poorly
ventilated area. Breathing exhaust fumes can cause
death.
3 2
5 3
7 5
940686187-01
To start a cold engine:
1. Press the primer bulb 10 times.
2. Set the choke lever to
3. Squeeze the throttle trigger completely and pull the
starter grip until the engine starts.
4. Do not pull the starter grip more than 8 times.
5. Set the choke lever to
6. Pull the starter grip until the engine starts. Do not pull
the starter grip more than 6 times.
7. Wait 10 seconds
8. Set the choke lever to
To start a warm engine:
1. Press the primer bulb 10 times.
2. Squeeze the throttle trigger completely and pull the
starter grip until the engine starts.
3. Do not pull the starter grip more than 6 times.
4. Set the choke lever to
5. Wait 10 seconds
6. Set the choke lever to
To stop the engine:
See Fig. 4.
Press the on/off switch to off position (O).
OPERATING THE BLOWER
See Fig. 5.
■ Slip your arm through harness strap and onto your
shoulder, then repeat for the other shoulder. Adjust
the straps to a comfortable position. Refer to Adjusting
English (Original instructions)
2
1 1
4
6 4
6
8 6
choke position.
choke position.
position.
choke position.
position.
the Harness and Waist Straps section earlier in this
manual.
■ Remove the product from your back for starting. To
start the blower, refer to Starting and Stopping section
earlier in this manual.
■ Put on the blower again. The product should be
operated on the operator's right side.
■ To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
centre of a pile.
■ Operate power equipment at reasonable hours only —
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in
local ordinances.
■ To reduce sound levels, limit the number of pieces of
equipment used at any time.
■ Operate the blower at the lowest possible throttle
speed to do the job.
■ Check your equipment before operation, especially
the muffler, air intakes, and air filters.
■ Use rakes or brooms to loosen the debris before
operating the product. Slightly dampen surfaces in
dusty conditions.
■ Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
■ Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
Do not place blower on top of or near loose debris or
gravel. Debris may be sucked into the blower intake
vent resulting in possible damage to the product and
serious personal injury.
19
CAUTION