Klarstein EasyCook Domino Manual De Instrucciones página 22

EN
22
• Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
• Carefully turn the hob back over and then gently lower it into the aperture hole that
you have cut out.
• There are holes on the base or the sides of the hob that you can fix the four brackets
to. There are three holes in each one of the brackets.
• You should place the bracket on the underneath of the hob, in a position that is
appropriate for the aperture that you have cut out. Using the screws provided,
fix the bracket to the hob. These screws MUST be securely tightened. Depends on
different models,there may be 4-5 pieces of brackets for the hob.
Screw hole
Screw
Bracket
Base
Screw hole
Screw
Bracket