GYS GYSCAP 680 E Manual De Instrucciones página 13

Press the start button. A 30-second countdown begins.
Start the vehicle to be serviced as soon as possible before its capacity is transferred to the battery.
Wait for the GYSCAP 680E to recharge until the digital display indicates
(once recharged, the GYSCAP 680E is ready for further troubleshooting).
After switching off the GYSCAP 680E with the button
Disconnect the GYSCAP 680E clamps from the vehicle.
Wrap the cables and store the clamps in the space provided.
If the vehicle to be serviced still does not start after 2 attempts, it is likely that the fault
is not related to the battery. Find the real cause of the fault before attempting to start
the vehicle again.
Failure of a first attempt will unload GYSCAP 680E.
i
Before a new attempt, reload GYSCAP 680E.
Refer to the paragraph «recharging GYSCAP 680E».
During special troubleshooting:
Connect the clamps of the GYSCAP 680E to the vehicle to be repaired, respecting the polarity.
Press the Power button.
The digital display shows the capacity status of the GYSCAP 680E.
Battery status display: voltage at the end of the clamps.
Press for 3 seconds to force the vehicle to start to troubleshoot.
A 30-second countdown begins.
Start the vehicle to be serviced as soon as possible before its capacity is transferred to the battery.
Wait for the GYSCAP 680E to recharge until the digital display indicates
(once recharged, the GYSCAP 680E is ready for further troubleshooting).
After switching off the GYSCAP 680E with the button
Disconnect the GYSCAP 680E clamps from the vehicle.
Wrap the cables and store the clamps in the space provided.
GYSCAP 680E
The vehicle's battery is in deep discharge.
.
:
.
:
EN
13