Changing The Paper Size - Lexmark T620 Guia Del Usuario

Changing the Paper Size

Your 2000-sheet drawer comes pre-configured for either letter or A4 paper size.
To change the paper size prior to installation, proceed to step 7 of the following
instructions now. If you are changing the paper size for a unit that is already
attached to a printer and a power source, proceed with step 1:
1
Open the loading door.
2
Push the elevator down button located on the left side of the door opening.
See illustration on page 17.
3
Remove paper from the elevator tray and close the loading door.
4
Re-open the door. The printer elevator tray should be approximately
halfway up.
5
Unplug the power cord.
6
Remove the printer and all attached options from the
2000-sheet drawer.
CAUTION!
7
Locate the paper size selector knob on top of the drawer. See page 12 for
an illustration and location of the knob.
8
To make a selection, turn the knob completely in a counterclockwise
direction. This action sets the paper size to legal (LGL).
9
Count the clicks as you turn the knob clockwise to find the correct
paper size. For example, one click sets the paper size to executive
(EXEC).
12
2000-Sheet Drawer User's Guide
Remove the attached options one at a time. Make sure your fin-
gers are not under the printer when you set it down. Use the
handholds on the printer or ask someone to help you lift it.
Note: Six paper selections are available. Each paper selection is
color-coded. A new paper size is displayed on the operator
panel after the paper elevator tray is in the up position.