Tabla de contenido
Publicidad
3.
Remove the wall plate template
CMK1*).
CAUTION:
Be sure the anchors are seated flush with the concrete surface.
4.
Install wall plate assembly
Installation Kit CMK1*). Tighten the lag bolts only until they are pulled firmly against the wall plate.
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
*
Contact Customer Service at 1-888-333-9952 to have the Concrete Installation Kit CMK1 shipped directly to you.
NOTE: If needed, you can make small level adjustments to the wall plate by loosening the bottom lag bolt and shifting the wall
plate until level. Tighten the bottom lag bolt when adjustments are complete (see page 11).
3
and insert two anchors (Fischer UX 10 x 60 - included in the Concrete Installation Kit
13
using two lag bolts and two washers (use only the lag bolts and washers from the Concrete
14
*
4
*
14
*
13
Publicidad
Tabla de contenido
