5. Lift glass front panel and remove
grease filter. Fig. 11.
6. Level the hood using (2) screws
provided on mounting brackets. Fig.
12.
7. Mark and install (2) additional drywall
anchors as shown. Fig. 13.
8. Secure range hood to the wall with
(2) 4.8 x 38 mm mounting screws.
9. Tighten upper screws on mounting
brackets until hood is tight against
the wall.
NON-DUCTED INSTALLATION -
CONTINUE TO STEP 10 AT TOP OF
PAGE 11.
DUCTED INSTALLATION -
SKIP TO STEP 17 AT BOTTOM OF
PAGE 11.
4.8 x 38 mm SCREWS
- 10 -
FIG.11
FIG.12
DRYWALL
ANCHORS
IN WALL
FIG.13