Tabla de contenido
Publicidad
4.
Place the wall plate template
template
and tape in place.
10
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5.
Drill the two pilot holes using a 5.5 mm (7/32 in.) diameter drill bit.
IMPORTANT
: Pilot holes must be drilled to a depth of 89 mm (3 ½ in.).
6.
Partially install the top lag bolt
NOTE: This space allows you to remove the wall plate template
4
at your desired height and position the slotted holes over your stud center line. Level the wall plate
10
, leaving about 13 mm (1/2 in.) space from the wall.
13
5
5.5 mm
(7/32 in.)
10
and hang the wall plate
10
89 mm
(3½ in.)
10
onto the top lag bolt
.
13
11
6
≈ 13 mm
( 1/2 in.)
10
13
9
Publicidad
Tabla de contenido
