Ransomes Commander 3520 Manual De Seguridad, Funcionamiento Y Mantenimiento página 69

11.1.3 MARCELLING ______________________________________________________
NOTE: Arrow indicates direction of travel.
Probable Cause
Mowing (ground) speed is too fast.
HOC (height-of-cut) setting is too low for turf condi-
tions.
Cutting reel diameter is worn.
Marcelling, like washboarding, is a cyclical pattern
of varying cutting heights, resulting in a wave-like cut
appearance. In most cases, the wave tip-to-tip dis-
tance is 2 in. (5 cm) or less.
TN0220
Reduce mowing (ground) speed.
Check/adjust HOC to turf conditions.
Check cutting reel diameter and replace if worn.
11 QUALITY OF CUT
Remedy
en-67