Brink 742041 Instrucciones De Montaje página 7

ATTENTION!
a) Ensure that all packing elements are fixed properly! Pay special attention to the packing at the
wire outlet from the plug – it must sit firmly on the insulation tube and not on the individual wires!
b) Lay the wire set in such a way that there are no chafe marks!
c) Do not lay the wire set in close proximity to the exhaust unit!!
The socket is wired as follows:
Cable
black/white
grey
brown
black/green
grey/red
black/red
grey/black
Position the rubber socket mounted on the wire set and inserts it into the conduit hole towards the
boot.
Lay the wiring-set end marked with an L (6-way socket housing) under the luggage compartment
floor-carpet to where the left-hand rear light is installed.
Draw back the car-side 6-way socket housing for the left-hand rear light into the interior, plug
together with the corresponding piece of the wiring-set and clip into place.
Lead the remaining 6-way socket housing of the portion of the wiring-set outside, plug into the
left-hand tail light and clip into place.
Refit the left-hand tail light.
Lay out the end of the set of leads marked
right-hand tail light is installed.
Draw back the car-side 6-way socket housing for the right-hand rear light into the interior, plug
together with the corresponding piece of the wiring-set and clip into place.
Lead the remaining 6-way socket housing of the portion of the wiring-set outside, plug into the
right-hand tail light and clip into place.
Refit the right-hand tail light.
052647a020216
Contact no. Function
1 Indicator, left
2 Rear fog light
3 Earth
4 Indicator, right
5 Rear light, right
6 Brake lights
7 Rear light, left
R
(6-way socket housing) to the place where the
7 / 32