Notes On Runtime; Indication: Clean The Grease Fi Lters; Indication: Replace The Charcoal Fi Lter; Turn Off The Carbon Fi Lter Operating Hours - Asko HIHM934M Instrucciones De Empleo Y De Montaje

Changing the after-run time of the extraction system
• Press simultaneously the extractor Plus key
Minus key . in order to change the time.
Cutting off the after-run of the extraction system
• Press the ON/Off key of the extractor
NOTE
If the extraction system has been in operation for at
least 15 minutes, an automatic after-run of 15 minutes
at level 1 runs to dry out the system.
Disable automatic after-run
1. Turning on the control via the on/off switch on the fan
.
2. Press the on/off button on the fan for approximately
3 seconds until
is permanently disabled.
Enable automatic fan run
1. Turning on the control via the on/off switch on the fan
.
2. Press the on/off button on the fan for approximately
3 seconds until
run is permanently activated.

4.25.3 Notes on runtime

The fan motor should continue operating for another
10-20 minutes every time the hob has been used for
cooking. When the fan is switched off after having been
in operation for at least 15 minutes, an automatic time lag
at a low setting will follow for around 15 minutes.
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air fi lter, please always
allow for a stop delay time of 10 - 60 minutes in order to
optimally remove cooking odours.
When the fan is switched on again, in rare cases the
odour molecules present in the fi lter may be combined
with steam so that they are detected again. These
remaining odours will disappear when the fan continues
to operate.
.
is displayed. The automatic fan
is displayed. The automatic fan
Operation
and
IMPORTANT
When the recirculation mode is in operation, ventilation
must be suffi cient in order for the air humidity to be
removed.
4.25.4 Indication: Clean the grease fi lters
After 10 hours of operation the display
cleaning appears. The grease fi lter must be cleaned,
otherwise there is a risk of fi re.
To continue to use the ventilation, confi rm the display
with the Minus key
If the grease fi lter has been cleaned, you can delete the
display by pressing the Minus key
OFF key on the extractor at the
3 seconds. The counter for the display starts again at 0
hours.
4.25.5 Indication: Replace the charcoal fi lter
After 150 hours of operation the display for Carbon
Cleaning appears
replaced.
To continue to use the ventilation, confi rm the display
using the Plus key to
If the carbon fi lter has been replaced, you can delete
the display
OFF key on the extractor at the
3 seconds. The counter for the display starts again at 0
hours.
4.25.6 Turn off the carbon fi lter operating hours

counter during the operation of the air exhaust

During the operation of the air exhaust, the operating
hours counter for the carbon fi lter must be turned off .
To do this, the control panel must fi rst be turned on using
the ON/OFF key of the fan
messages displayed.
Then simultaneously press the Plus key
OFF key from the fan
The display will show
hours counter for the charcoal fi lter is turned off .
To turn the operating hours counter back on, repeat the
operation.
The display will show
hours counter for the charcoal fi lter is now turned on.
.
same time for at least
. The charcoal fi lter needs to be
.
by pressing the Plus key
same time for at least
and there may not be any
for 3 seconds.
(carbon off ) and the operating
(carbon on) and the operating
GB
for fi lter
and the ON/
and the ON/
and the ON/
17