Craftsman 25098 Manual De Las Instrucciones página 23

Tabla de contenido

Publicidad

2
_'_
INSTALL
MOWER
AND DRIVE
BELT
Be sure tractor is on level surfase and mower suspension arms
(3) are raised with attachment
lift control. Engage parking
brake.
Cut and remove ties securing anti-sway bar (1) and belts.
Swing anti-sway bar to left side of mower deck.
Slide mower under tractor.
IMPORTANT:
CHECK
BELT FOR PROPER
ROUTING
IN
ALL MOWER
PULLEY
GROOVES.
Lower mower suspension
arms (3) with attachment
lift
control.
Be sure belt tension rod (2) is in disengaged
position.
Install belt into electric clutch pulley groove (8).
Place the suspension arms (3) on outward pointing deck
pins. Retain with double loop retainer springs (B).
Install front plate assembly (4) to tractor suspension brack-
ets (5) and retain with single loop retainer springs (A) as
shown.
Position front plate assembly between front mower brack-
ets (6). Raise deck and plate assembly to align holes and
insert flanged pins (7). Secure pins with double loop
retainer springs (B) between the plate assembly and
mower brackets.
NOTE: To assist in Iocatinghole in flanged pin (7) the hole in
p n s inline with notch onhead of pin.
Engage belt tension rod by pushing rod (2) into locking
bracket (9).
Connect anti-sway bar (t) to chassis bracket (10) under
left footrest and retain with double loop retainer spdng (B).
Raise deck to highest position.
Adjust gauge wheels (11) before operating mower.
1. Anti-sway bar
2.
Belt tension rod
3.
Suspension
arms
4.
Front plate assembly
5.
Tractor suspension bracket
6.
Front mower bracket
7.
Flanged pin
8.
Clutch pulley
9.
Locking Bracket
10. Chassis bracket
11. Gauge wheel
A. Single loop retainer spring
B. Double loop retainerspring
9
3
11
6
8
p
23

Publicidad

Tabla de contenido
loading

Tabla de contenido