Festo SLG Serie Instrucciones De Utilizacion página 27

SLG−...
Tighten the one−way flow control valves:
S
at first completely
then loosen again approximately one
turn.
Pressurize the component as follows:
S
First pressurize both sides and
then one side. The slide will then move into an end position. In this way you
will avoid overloading the component and the compressed air network.
Start a test run.
S
During the test run:
check whether modifications are required to the following settings:
S
the speed of the moving mass (restrictor settings)
the position of the end stops (rough and accurate settings).
With masses which project longitudinally over
the slide
Interrupt the test run while you are oper
S
ating the locking screws of the end stops.
Open the one−way flow control valves
S
slowly until the desired slide speed is
reached.
Conclude the test run.
S
Festo SLG−... 0802d English
Fig. 23
Fig. 24
Fig. 25
27