Preparation; Insertion/Replacement Of The Batteries; Connection Of The Lead Wires To The Device - Empi Phoenix Manual De Usuario

7.3 Preparation

7.3.1 Insertion/replacement of the batteries

Remove the belt clip by disengaging
1.
one of the arms on the side of the
device.
Remove the battery door by sliding
2.
it downward along the device.
Place the batteries as indicated
3.
on the bottom of the battery
compartment.
Note the polarity and the battery
type. Use only IEC LR06 AA 1.5 V
Alkaline or rechargeable AA NiMH
1.2 V batteries.

7.3.2 Connection of the lead wires to the device

Always inspect the lead wires connection before using them. If any connection is damaged, do not use the lead wire and
replace it.
Connect Channel 1 and Channel 2
1.
lead wires into their respective socket
as shown.
Make sure the lead wire is fully
2.
engaged by pressing the leadwire
connector head firmly into the
socket.
Correct Incorrect
Phoenix User's Manual
Close the battery door by sliding it
4.
upward until it clicks into place as
shown. Make sure the battery door
is fully engaged before switching on
the device.
You may or may not use the belt clip, as you prefer.
5.
Dispose of the old batteries in accordance with local and
6.
national regulations.
Remove the batteries from the Empi Phoenix device if it
is not used for a prolonged period of time (e.g. more than
3 months).
You may not need to insert Channel 2 lead wire,
3.
depending on the program and electrode configuration
you are using. Consult your clinician for instruction
on how to use the appropriate program and proper
placement of the electrode (see also Section 6.4 of this
manual).
To disconnect the lead wire, pull the
4.
lead wire connector head away from
the connector. pull on the lead
Never
wire directly to remove it from the
device, as this may damage the lead
wire.
19