Cleaning Solution Filter; Machine Body; Batteries; Pb-Acid - Lavor COMFORT XXS A12 RIDER KRON PICO Manual De Instrucciones

Remove and clean the brushes or the scraper disks.
• To avoid damaging the floor and the machine,
carefully check if foreign matter, such as metallic
parts, screws, chips, cords or similar items, has
become jammed. Check that the brushes are flat
as they work on the surface (check for any irregu-
lar wear on the brushes or on the abrasive disks).
If necessary, adjust the slant of the action on the
floor. Use only the accessories recommended by
the manufacturer: other products may reduce op-
erating safety.
8.5

CLEANING SOLUTION FILTER

Make sure that the detergent solution tank is
empty. Check and clean the solution filter located
in the lower front part of the machine. Clean with
running water if necessary and check that the de-
tergent solution is being delivered on the brushes.
Fully tighten the filter to prevent leaks during op-
Remove and wash the squeegee
Drain the recovery tank
Drain, rinse with clean water or sanificate the recovery tank
Charge the batteries
Check the acid level in the battery cells (if batteries are not
maintenance-free)
Remove brushes and check for brush wear, foreign bodies
and wrapped belts
Verify the machine general conditions.
Verify that suction hose and conduct are free from obstruc-
tions
Check the wear of the squeegee rubber blades
Open and clean the solution water filter
Clean the brush plate, squeegee support and squeegee
Check the lifting/lowering of the brush plate.
Check the lifting/lowering of the squeegee.
Grease the moving parts.
Check the control cable for the opening of the solution water
tap.
Verify the security devices ( emergency switch, mechanical or elec-
tromechanical brake, operator safety switch, etc).
Descale water hoses.
tion and irreparably reduce the element's operating
capacities. An overflowing acid solution may cor-
rode the machine. Use battery chargers recom-
mended by the manufacturer and, in any case,
those that are suitable for the type of battery to be
eration.
8.6

MACHINE BODY

Use a sponge or a soft cloth to clean the exterior of
the machine and, if necessary, a soft brush to elimi-
nate tough dirt. The machine's shockproof surface
is rough to make it harder to see scratches caused
during use. However, this does not make it easier
to remove tough stains on the surface. Steam ma-
chines can be used but it's prohibited to use hoses
with running water or a high-pressure cleaner.
8.7

BATTERIES

8.7.1

PB-ACID

Carry out maintenance operations in accordance
with the manufacturer's instructions and with all
the other instructions provided in this manual.
Exposing the element plates (not completely im-
mersed in the acid solution) will lead to rapid oxida-
When After
needed every use
X
X
charged. Always charge batteries in well-ventilated
rooms: there is an explosion risk!
The use of gel or maintenance-free batteries is
highly recommended.
37
Weekly
X
X
X
X
X
X
X
X
X
Monthly
X
X
X
X
X
X
X