Environmental Protection - Triton MOF001 Instrucciones De Uso

SYMBOLS

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Always wear ear, eye and respiratory
protection.
Conforms to relevant legislation
and safety standards.
FUNCTIONS
POWER SWITCH
When the router is connected to power the switch (11)
will illuminate (in both "on" and "off" positions).
The retracting switch shutter (12) prevents accidental
starting of the router. It must be retracted before the
router can be switched on. The cover will remain open
until the router is switched off.
CUT DEPTH ADJUSTMENT
There are three methods of cut depth adjustment,
depending on the accuracy and control required: Free
Plunge, for conventional & fast depth adjustment; Handle
Winder Plunge, for controlled & fast adjustment; and
Micro Adjuster, for precise depth setting throughout the
full plunge range.
FREE PLUNGE
1. Free plunge depth
adjustments can be
made with the Plunge
Mode Selector button (5)
engaged. Press it deep
GB
inside the handle until it
engages inward.
2. Release the Plunge Lock
Lever (15). Push the body of the router until the
desired depth is reached. Re-lock the plunge lock
lever.
The position of the plunge lock lever
can be altered by removing its retaining screw
Symbols / Functions
6
Instruction warning.
Instruction note.
Double insulated for additional protection.
and repositioning the lever on the bolt. Re-tighten
firmly.
HANDLE WINDER PLUNGE
1. Handle Winder Plunge depth
adjustments can be made
when the plunge mode
selector button is flush with
the handle.
If engaged, press the
Plunge Mode Selector
button (5) inward and allow
it to spring out flush with the handle. Ensure the
Plunge Lock Lever (15) is unlocked.
2. Pull the Winder Handle
Clutch Ring (4) into the
handle then turn the handle
to raise or lower the cutter.
Release the ring at the
required depth, allowing it to
"pop out", locking the cutter
at the desired depth.
3. Lock the plunge lever, particularly for heavy cuts.
MICRO ADJUSTER
For use in the Handle Winder Plunge Mode only.
1. Disengage the Plunge Mode
Selector button (5), and
ensure that the plunge lock
lever (15) is unlocked.
If the micro winder (2) is
turned with the plunge
lock lever engaged the
micro winder will start
clicking and the cut depth will remain
unchanged.