Work Procedure - REMS Cento Instrucciones De Servicio

g
REMS DueCento
pipe cutting machine. Do not allow the pipe (5) to knock against the cutting
base because otherwise a pipe running off centre could break he cutting wheel.
CAUTION
nut for fastening the cutting wheel (right-hand thread) with the size 27 ring
hexagonal nut.
NOTICE
An unsuitable cutting wheel will be damaged or the pipe will not be cut. Use
only original REMS cutting wheels!
REMS DueCento.
3. Operation
CAUTION
Danger of injury!
long hair can get caught in moving parts.

3.1. Work procedure

CAUTION
pipe to be cut (5) can be placed on he rollers (3). Outside burr (sawing burr)
sure that the REMS cutting wheel (2) suitable for the pipe to be cut is selected/
of a clock). Let the pipe turn about another 2 turns without further feeding before
NOTICE
3.3. Deburring
Deburring of inside of pipe
REMS cutting wheel Cu (Art. No. 845053) and REMS cutting wheel RF (Art.
rest(s) (10) for deburring longer pipes.
Danger of injury!
Loose clothing, jewellery or
NOTICE
the REMS REG 28 – 108 (12) (Fig. 3).
deburred on the outside and inside. There is a bit holder on the back of the
-
NOTICE
only
4. Maintenance
4.1. Maintenance
WARNING
Keep the rollers (3) of the pipe cutting machine and the roller insert (14) clean.
rust.
(Art. No. 140119) or a mild soap and a damp cloth. Do not use household
cleaners. These often contain chemicals which can damage the plastic parts.
WARNING
The gear of REMS Cento and REMS DueCento is maintenance-free. It runs
g
-