Installation - Sharp LL-S242A-W Manual De Instalación

You can install the touch display for each monitor in the
following positions.
Installation position
Standing Rack stand
position
Variable stand
Pen writing position
Horizontal position
Installing on a stand
(Standing position)
nLL-P202V
Placement on the variable stand
Place the unit on the supplied variable stand.
Caution
• The variable stand is designed for placement of the unit in
the landscape orientation. It cannot be used for the portrait
orientation.
• For installation, place the monitor face-down carefully on a
soft cloth on top of a flat, stable surface.
• Applying excessive pressure to the LCD panel with your
hands may result in damage to the unit.
• Be careful not to get your fingers caught when adjusting the
angle, for example.
1. Place the variable stand on the rear of the monitor,
insert the fixing screws and tighten by hand to position
the stand.
2. Securely tighten the fixing screws using the supplied
hexagonal wrench.
8
E

Installation

LL-S242A-W LL-P202V
Yes No
No Yes
No Yes
Yes Yes
3. Place the monitor in the standing position, and adjust
the angle of the stand.
Hold the display with one hand so that it does not fall over,
hold the rear leg of the stand with your other hand, and
adjust the angle of the stand.
The legs can extend about 20 to 75 degrees in relation to
the flat surface.
20°