Connecting Peripheral Equipment; Connection With A Pc - Sharp LL-S242A-W Manual De Instalación

Caution
• Be sure to turn off the power and disconnect the plug from
the power outlet before connecting/disconnecting cables.
Also, read the manual of the equipment to be connected.
• Do not forcibly bend or apply force to cables. Doing so may
result in wire breakage or other damage.
• When connecting cables, spread a soft cloth on a stable
level surface such as a desk, and gently place the monitor
on it with the screen facing down.
• Do not use any cable that has a damaged or deformed
terminal. Using such cables may cause malfunctions.
• Connect USB devices that have the following thicknesses
around the connector area.
D
B
C
TIPS
• Images may not be displayed properly depending on the
computer (video card) to be connected.
• To use the digitizer pen, the necessary software must be
installed on the computer from the supplied CD-ROM.
• When connecting a USB device to the USB terminal, use
only USB devices with current consumption of 500mA or
lower.

Connection with a PC

Connect the monitor and a PC using the connection cable.
nInputting video and audio
HDMI input terminal
Commercially available HDMI cable
(conforming to the HDMI standard)
HDMI input terminal
Check the orientation of the connector and insert it horizontally
as far as it will go.
• It is possible to connect the monitor's HDMI input terminal
to a smartphone or similar MHL-compliant device using a
commercially available MHL cable.
This product supports MHL 1.
6
E

Connecting Peripheral Equipment

A 12mm
B 38mm
C 8mm
A
D 17mm
To HDMI output
terminal on PC
DisplayPort input terminal
Commercially available DisplayPort cable
DisplayPort input terminal
Check the orientation of the connector and insert it horizontally
as far as it will go.
TIPS
• The length of the signal cables or surrounding environment
may affect the image quality.
• The video from the terminal that has signal input is
displayed. In this state, even if a signal is input from the
other terminal, the display is not switched. To switch the
display, use [Input Select] on the menu screen.
• If the LCD monitor is turned on when there are input signals
from both terminals, the video from the DisplayPort input
terminal is displayed (factory default).
• The terms HDMI and HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or registered
trademarks of HDMI Licensing LLC in the United States
and other countries.
• DisplayPort is a registered trademark of Video Electronics
Standards Association.
• MHL, the MHL logo, and Mobile High-Definition Link are
trademarks or registered trademarks of MHL, LLC in the
United States and other countries.
nUsing the touch panel
To use the touch panel, connect the monitor to a USB port on
a PC using the supplied USB cable.
Supplied USB cable
USB terminal
Touch panel terminal
Check the orientation of the connector and insert it horizontally
as far as it will go.
To DisplayPort output
terminal on PC
To USB port on PC