Troubleshooting; Safety Warnings - Astralpool LUMIPLUS Manual Para La Conexión Eléctrica

6. TROUBLESHOOTING:

Problems
The lamp or spotlight is not
working
The lamp projects a different
colour to that shown on the
Control Motion Central Display
Two lamps project different
colours
Using the control motion mode,
the lamp or spotlight does not
work
Control Motion is not responding

7. SAFETY WARNINGS:

• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
8. ASSEMBLY AND FUNCTIONING WARNINGS:
• The projector and the lamp are designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• The Global projector is seawater resistant.
• The projector and the lamp resistance the treatments of swimming pool described next as long as the values of
concentration do not surpass the following values:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
The lamp or spotlight does not
have a power supply
The lamp/s or spotlight/s do not
receive information
The Control Motion batteries are
low
TYPE OF TREATMENT
Usual causes
CONCENTRATION IN WATER
5
Solutions
Connect the lamp or spotlight
to the power supply through a
12 V~ac safety transformer.
1. Get close to the lamp or
spotlight before sending a
command
2. Do not cover the antenna
with your hand
3. Press the REFRESH button
Change the batteries
2 g/l
5 g/l
6 g/l