Electrical Connection - Astralpool LUMIPLUS Manual Para La Conexión Eléctrica

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the LumiPlus Wireless Projector, follow the instructions provided below:

1. ELECTRICAL CONNECTION

The projectors are supplied with a 2-wire 1.5mm2 Cu H07RNF cable.
You should make sure that the voltage received by the lamp is never more than 12V~AC, by a safety transformer. The
transformer must be sized to provide the VA for each LED projector that is connected. See power table, last page.
2. CONTROL MOTION:
Operating frequency: 868 MHz
Range in the open field: 5 m
Batteries: 2 AAA-1.5 V batteries.
Control Motion has 6 buttons: COLOR, REFRESH, SEQUENCE, SPEED (-/+), ON/OFF
The main functions on the remote control are:
• COLOR: selects one of 12 standard colours available.
• REFRESH: recovers the colour/sequences
• SEQUENCE: selects one of the 8 sequences available.
• SPEED: selects one of the 8 speeds available.
• ON/OFF: switches the lamp/s or spotlight/s on and off.
DO NOT PLACE HAND OVER TOP
OF THE BUTTONS ON CONTROL MOTION
3. OPERATION:
Control Motion is able to control lamp/s or spotlight/s through the buttons or movement.
In order for a lamp to respond to Control Motion, it must be placed near the lamp/s or spotlight/s. If you have more than
one lamp, place it in the middle of them to ensure optimum reception.
3.1 Remote control
- Switching spotlights on
By pressing the ON/OFF button for a few seconds, the spotlights will turn on.
- Selecting colours
The COLOR button enables you to select one of the 12 available colours. Each time the button is pressed, the colour
changes; when the last colour is reached, pressing again goes back to the first colour. The colour selected is displayed in
the Central Display.
COLOUR Nº
- Selecting sequences
The SEQUENCE button enables you to select one of the 8 available sequences. Each time the button is pressed, the
sequence changes; when the last sequence is reached, pressing again goes back to the first sequence. All sequences work
ATTENTION
COLOUR
1 Red
2 Green
3 Blue
4 Yellow
5 Cyan
6 Magenta
COLOUR Nº
7
8
9
10
11
12
3
REFRESH
CENTRAL DISPLAY
COLOR
SEQUENCE
SPEED -/+
ON/OFF
COLOUR
Sky-blue
Pale violet
Orange
Pink
Emerald green
White