Hkoenig SWR22 Manual De Utilización página 13

Dockinq station :
Using method & functional status of the docking station
No. Function guide
LED decorative
1
lioht
2
Decorative light
switch
3
Power LED
4
Charging indicator
5 Signal transmitting
6,7
Recharging
positive & negative
electrode
8 Charging power DC The power DC socket, called recharger for short, used ta connect output terminal
socket
Trouble shooting :
The cleaner doesn't work or clean poorly :
1. Check whether turning on the switch.
2. Check whether the dustbin, filter and intake are clean, and whether the side brush works.
3. Check whether the battery voltage declines greatly.
The remote control doesn't work :
1. Check the battery status of the remote control.
2. Check the battery status of the robot.
3. Whether check code between the remote control and main body.
4. Check whether the remote control is within the available scope of the signal transmitting.
1. LED decorative light (a little essence can be placed above)
2.Decorative light switch
3.Power LED
4.Charging indicator
5. Signal transmitting
6. Charging positive electrode
7. Charging negative electrode
8. Charging power DC socket
Turn on the decorative light ta activate the atmosphere, and place in the glowing
center of the light a little essence, wich will give off charming aroma after heating.
Press the switch ta turn on/off while the decorative light is on.
The power LED will light when the docking station is connected with the power, or
tu rn off if net con nected.
The indicator will flicker while the recharger is connected with the cleaner.
Transmitting signal is the only way ta lead the cleaner ta return the docking
station for charging, sa the signal transmitting position should be clean for long
without any obstacle on il.
The electrode and that of the cleaner are connected ta charge under contact
mode, sa the position should be clean without any obstacle on it while using, or
there will be impact ta the charging.
DC24V of the adapter, is the charging transit station between the cleaner and
adapter, sa the recharger should be placed against the wall firmly and the adapter
cable should be away from the recharger, or the robot may have impact and
winding during cleaning.
Function Information