Tabla de contenido
Publicidad
Motor Shaft
Belt
Courroie
Correa
Motor Shaft
Arbre du moteur
Eje del motor
Belt Groove
Rainure de la courroie
Polea para correa
End Cap
Bouchon
Tapa del
extremo
Agitator
Slot
Agitateur
Fente
Agitador
Ranura
Replacing Belt
Arbre du moteur
Eje del motor
Agitator
Agitateur
Agitador
Nozzle
Tête d'aspiration
Boquilla
➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ Remove lower plate. See
"Removing and Installing Lower
Plate"
➢ Remove agitator by carefully lifting
out.
➢ Remove worn or broken belt.
➢ Clean agitator and the end caps
(page 48).
➢ Loop new belt around motor shaft
and agitator belt groove; see
illustration for correct belt routing.
➢ Reinstall agitator back into nozzle
housing grooves.
➢ After reinstalling the agitator, turn it
by hand to make sure that belt is
not twisted or pinched and that all
rotating parts turn freely.
➢ Reinstall lower plate. Ensure tabs
are locked into slots.
- 46 -
Publicidad
Tabla de contenido
