Installation; Power Supply; Operation Using The Mains Adapter; Operation Using Batteries - Promax SATHUNTER Manual De Instrucciones

SATHUNTER USER'S MANUAL.

3. INSTALLATION

3.1 Power Supply

The SATHUNTER is a portable instrument powered by a lithium rechargeable
battery. The instrument comes with a mains adapter in order to connect it to the mains
for operation and battery charging.

3.1.1 Operation using the Mains Adapter

Connect the mains adapter to the SATHUNTER using the external power
connector [4] (see Figure 6.-) located on the right side panel. Connect the
adapter to the mains and it will automatically start the battery charging process. The
equipment will emit an acoustic indication. It will also display information about the
battery charging (see "3.1.3 Battery Charging") on the screen. When the battery is
already charged, the instrument will automatically disconnect. To stop the charging
process, press any of the three keys
(the battery-charging screen will disappear).
To start operation, keep any of the three instrument keys (
[3]) pressing down for more than 1 s. The instrument will start up. The battery
charging process will stop until the equipment starts up. The charging process will be
slower when the equipment is on.
Before using the mains adapter, make sure that it is the appropriate one for your
mains system: Mains power adapter model AL-101B.
The mains adapter is exclusively designed for indoor use.

3.1.2 Operation Using Batteries

The instrument is powered by a 7.4 V and 2.2 Ah Li-Ion battery.
In order to the equipment works using the battery, you need only press any
instrument key ( [1],
charged, the SATHUNTER has an approximate autonomy of 80 minutes in continuous
operation and at the worst conditions (powering a universal LNB and identifying a
signal).
11/2009
[1], [2] or
[2] or [3]) for more than 1 s. With the battery fully
[3], for more than 2 s
[1], [2] or
CAUTION
Page 7