Ryobi P620 Manual De Utilización página 9

GB
FR DE ES
MAINTENANCE
Replace the spray tip and rotate clockwise to secure.
Q
Reinstall the suction tube and filter.
Q
Reinstall the paint container.
Q
The sprayer is now ready to be stored.
Q
REPLACING ATOMIZER VALVE ASSEMBLY
The atomizer valve causes the paint or stain material to
spin as it comes out of the sprayer. After 25 to 35 liters of
TROUBLESHOOTING
PROBLEM
Motor does not run.
Motor overheats.
Motor has a low hum but does
not spray.
Motor seems to be running
properly but doesn't spray.
Sprayed material is spitting or
globbing up.
Paint/stain spray overspray is
excessive.
Paint/stain runs or sags on the
work surface.
Paint/stain is leaking behind the
spray tip.
IT NL PT DK SE
CAUSE
Battery is not charged.
Piston has seized up.
Continuous spray operation.
Piston has seized up.
Suction tube and fi lter are loose or
damaged.
Atomizer valve is clogged or worn out.
Material being sprayed is too thick.
Plugged spray tip or intake fi lter; worn
piston.
Paint container volume is getting low.
Material being sprayed is too thick.
Suction tube is loose.
Atomizer valve is clogged or worn out.
Worn spray tip or piston.
Spray tip is too far from the surface
being sprayed.
Proper paint methods
observed.
Spray tip is loose.
Atomizer valve is worn or not positioned
properly.
FI NO RU PL CZ
English
paint or stain, the atomizer valve may no longer produce
a good spray pattern and may need to be replaced.
To replace:
Q Remove the battery pack from the sprayer.
Q Rotate the spray tip counterclockwise and remove.
Q Remove the atomizer valve assembly and discard.
Q Install the new atomizer valve assembly.
Q Replace the spray tip and rotate clockwise to secure.
Charge battery.
Thoroughly clean the sprayer using long term storage
cleaning instructions in the Maintenance section of this
manual.
Release trigger at the end of each pass to allow the
motor to cool.
Thoroughly clean the sprayer using long term storage
cleaning instructions in the Maintenance section of this
manual.
Reinstall or replace suction tube and fi lter as needed.
Clean or replace atomizer valve.
Follow material manufacturer's directions and thin
material as needed.
Thoroughly clean the sprayer and, if necessary, replace
piston, using storage cleaning instructions in the
Maintenance section of this manual.
Refi ll paint container.
Follow material manufacturer's directions to thin material
as needed.
Reinstall suction tube securely.
Clean or replace atomizer valve.
Clean or replace spray tip or piston.
Hold sprayer closer to the surface being
sprayed.
not being
Refer to Operating the Sprayer earlier in this manual.
Tighten spray tip.
Replace or reposition atomizer valve as needed.
5
HU RO LV LT EE
POSSIBLE SOLUTION
HR SI SK GR TR