GE UNC15 Manual Del Propietario E Instrucciones De Instalación página 8

ICE MACHINE LOCATION AND PREPARATION (Cont.)
Utility and Operational Requirements
• This ice machine must be connected to a potable
water supply.
• The water supply must have a conductivity of at least
The water to this ice machine must be potable, or
fit for human consumption. During ice making some
minerals will stick to the ice making components.
The higher the mineral content, the more mineral
build up will occur. Water filters are a partial help,
as they will remove the suspended solids, but water
treatment is needed for the dissolved solids, which
are part of the water and cannot be filtered out. We
your water inlet line such as GE Appliances Model
to review the installation instructions and determine
which filter will suit your application. In Canada visit
GEAppliances.ca.
This machine can be supplied with Reverse Osmosis
water, but the water conductivity must be no less
should include post treatment or blending to satisfy
the R.O. water's potential aggressiveness.
damage the machine.
Because water softeners exchange one mineral
for another, softened water may not improve water
conditions when used with ice machines.
Installation Instructions
GEAppliances.com
This ice machine is designed to operate in a wide
range of air temperatures with a minimum air
Although the machine will function within the listed
ranges, it works best at water temperatures between
NOTE: Ice making capacity goes down as the
environmental temperatures go up, and will be
Operating a unit outside of the limits can cause
problems that are not covered by the warranty and, if
extreme, cause damage to the unit.
This machine can be built into a cabinet. It is an
air cooled refrigeration system. Air flows in and out
of it through the grill at the bottom front. The grille
must not be blocked by any covering door, or other
obstruction.
49-1000436 Rev. 0