Advance Planning - GE UNC15 Manual Del Propietario E Instrucciones De Instalación

ADVANCE PLANNING

CAUTION
Due to excessive weight, TWO
PEOPLE ARE REQUIRED TO MOVE AND INSTALL
THIS Ice maker. Failure to do so can result in back or
other injury.
Cutout & Product Dimensions
49-1000436 Rev. 0
Installation Instructions
Installation Notes
A drain pump is available for this ice machine. The
GEApplianceparts.com or by calling
In Canada visit GEAppliances.ca or
call 800.561.3344.
Built-In Installation: If a finished floor is to be installed
in the area after the ice machine has been built in,
shims the expected thickness of the floor should be
installed under the unit to keep the machine level with
the planned floor level.
NOTE: The water connection is at the back and adds a
few inches to the cabinet depth.
Installation on a slab: You will need to install a drain
pump to the appliance and pump the water to the point
of drainage. See Accessories. Pumps will pump 1
Installation over a crawl space or basement:
Accessories. If there is not enough room behind the
machine for a drain/waste receptacle, the drain will
have to be below the floor.
NOTE: When installed in a corner, the door swing may
be limited due to handle contact with the wall or cabinet
face.
A water supply is required. Water supplies vary in the
degree of mineral content. High mineral content water
will require more frequent maintenance. Water filtration
may improve the taste of the ice as well as cut down on
some of the mineral build up.
Either
9