Care And Cleaning; Cleaning The Outside; Cleaning The Condenser - GE UNC15 Manual Del Propietario E Instrucciones De Instalación

Care And Cleaning

Cleaning the Outside

The stainless steel door and door handle can be
cleaned with a commercially available stainless steel
and small blemishes.
direction of the brush lines with a damp soft sponge. Do
not use appliance wax or polish on the stainless steel.
Removing Scale from the Ice Making System
Cleaning the ice machine involves adding a solution
of scale remover and water to the ice machine and
continuing to add it as it makes ice. The scale remover
must be diluted to the correct ratio. A squirt bottle will
make adding the scale remover much easier when the
unit is built in. If not built in, remove the top panel for
reservoir access.
You should use rubber gloves when using the
scale remover. To order scale remover,
GEApplianceParts.com
1. Scoop out and discard all of the ice.
2. Press and release the ON/OFF button.
POWER
ICE
ON/OFF
MAKING
3. Open door and locate screws at the upper back wall
of the bin. Remove the 2 screws.
16
go to
CLEAN
CHECK TIME TO
RESET
WATER CLEAN
Remove screws

Cleaning the Condenser

The condenser has fins and tubes that can become
clogged with dirt and lint.
To clean:
1. Remove the kickplate and front service panel.
2.
3.
NOTICE
Do not dent the fins.
4. Return the kickplate and front service panel to their
the original screws.
4. Remove the back panel of the bin by lowering it
down past the scoop holder. The scoop holder will
rotate to allow the panel to lower.
Reservoir cover
release tab
position before the reservoir cover can be removed.
Tab to Release
Condenser surface
OFF
Water
Shutoff
49-1000436 Rev. 0