Installation And Connection; Installing The Transducer - Balluff BTL5-A/C/E1-M-SF-F Serie Manual De Instrucciones

BTL5-A/C/E1_ -M _ _ _ _ -SF-F _ _
Micropulse Transducer - Rod Style
4

Installation and connection

4.1

Installing the transducer

For holding the transducer and float we recommend
non-magnetizable material.
Installing the float
1. Install the float (accessory) taking the orientation into
account (raised markings on top, see Figures 4-1 and
4-2).
2. Secure the float using the cotter pin (included in the
scope of delivery of the float), without placing any
mechanical loads on the rod. Guide the cotter pin
through the hole until it engages (see Figure 4-3).
www.balluff.com
Fig. 4-1: Installing the float
Fig. 4-2: Raised markings on float
Fig. 4-3: Inserting the cotter pin
english 7