Balanced Body Allegro Reformer Manual De Instrucciones página 23

How to install your Allegro®
Wall Security Strap
The Allegro Wall Security Strap is designed to mount on walls with standard wood framing. If you have a different type of wall
construction (brick, concrete, etc.), it may require a different fastener. Check with your local hardware store or contractor.
Parts List (included)
» 1 adjustable belt strap
» 1 3-1/2" eye-bolt
Tools Needed (not included)
» Drill with 1/8" bit
» Phillips or flathead screwdriver
INSTALL THE EYE-BOLT
1. Find a stud in the wall where you would like to stand your
Allegro. Make sure you have ample space on both sides of
the stud as well as above for the Allegro. Using a 1/8" drill bit,
pre-drill a hole into the stud. The hole should be positioned 5'
to 5 1/2' above the floor. Secure the eye-bolt into the pre-
drilled hole with the screwdriver until the shaft of the eyebolt
is completely within the wall.
USING THE WALL SECURITY STRAP
2. Follow your Allegro or Allegro
Tower instructions for proper
standing procedure.
3. Move the Allegro near the
wall with the footbar
pointed away from the wall
(perpendicular to the wall).
4. Wrap the strap ends around
one rail and connect the
ends like a belt, using the
adjustable clip.
5. Adjust the strap to remove
any slack.
NOTE: Do not try to wrap the strap ends around the entire frame
- it will not fit.
IMPORTANT: Balanced Body is not responsible for any damage or
injury caused by improper wall mount installation, or the use of
incorrect or improper wall mounting equipment.
If you have any questions, please call Balanced Body at
1-800-PILATES (1-800-745-2837) in the U.S. and Canada, or
+1-916-388-2838 (international).
21