Parts; Mounting - Truper ESRE-1/4N Manual De Instrucciones

Nozzle Axis
collar
Axis
Accessory mounting
• Insert the accessory shank (A) into the nozzle orifice (B).
• Using one of the included wrenches, hold the axis in
place (C).
• Meanwhile, using the other wrench, turn the nozzle
in a clockwise direction (D) to tighten the accessory.
• To loosen and remove the accessory turn the nozzle
counterclockwise.
CAUTION • Once the accessory is set, run the
grinder with no load for at least one minute. In case of
vibration change the accessory immediately.
• The attachment (E) tang must not protrude more than
5/16 '' of the nozzle, overcome this distance may cause
vibration.
6
ENGLISH
Ventilation
slots
Wrenches for
accessory installation

Mounting

(Accessories not included)

Parts

Switch
button
B
D
Speed
control
Power Cord
Ventilation
Protector
slots
A
C
E