Parts; Assembly - Truper ERGO-PRO ERGO-4580 Manual

Axis
lock
Clamp
lever
4 / " abrasive
1
2
disc included model ABT-386
Outer
flange
Inner
flange
Auxiliary handle
assembling orifice
Clamp
lever
Protection Guard Assembly
• Open the clamp lever and align the protruding parts inside the guard, push the
guard down until the protruding parts engage and rotate freely with the
corresponding slots in the shaft cover.
• With the clamp lever open, turn the guard to the desired working position.
• Fix pushing the clamp lever.
Protective
guard
Disc Assembly
1. Fit the inner flange onto the axis.
2. Set the disc onto the inner flange.
3. Set the outer flange onto the axis.
• Press the axis lock into the grinder head.
4. Screw the outer flange with the lock nut wrench until securely fastened.
DANGER
The axis lock should only be used to change discs.
Never use the axis lock to stop the disc while rotating.
After installing and inspecting the accessory, operate the tool at maximum speed without
load for one minute. Damaged accesories usually break during this period of time.

Parts

Protective
guard
Auxiliary
handle

Assembly

Slot
Handle
Switch
4 / " abrasive
1
2
disc included
Switch
Protective
guard
Lock nut wrench
LED, Power
indicator
Power cord
protector
Vent
slots
Lock nut
wrench
3
2
Disc
Inner
flange
5/8-11-UNC-1A
Grinder
head
ENGLISH
ENGLISH
(Included)
Axis
lock
Protective
guard
Power
supply cable
4
Outer
flange
1
7
7