Parts; Assembly - Truper TPN-875-2 Manual De Instrucciones

Parts

Collet
Nut
1/4" Chuck
Trigger
Lock
Accesory Installation
• Double check the accessory rod (A) is the same size as
the installed chuck diameter (B).
• Use only accessories specified for the grinder RPM or
bigger.
WARNING
• Disconnect the grinder from the air
supply before setting or removing accessories.
• Use the wrenches included to change accessories.
• Hold the spindle with the wrench (C) and with the
second wrench loosen the collet nut (D).
• Insert the rod up to the bottom of the accessory in the
chuck.
• Hold the spindle with the wrench and tighten the collet
nut until the accessory y perfectly secured.
• To change the chuck, remove the collet nut completely.
Replace the chuck and set the collet nut back.
• Remove the air input cap and set the fast connector (E)
(not included) in place. Tighten using one of the
wrenches.
Handle
Regulating
Screw
Mounting
Wrenches

Assembly

B
A
Trigger
Switch
Air Input
C
D
E
ENGLISH
7