Parts; Assembly - Truper ESMA-4-1/2A3 Manual De Instrucciones

Axis
lock
Abrasive disc
4 / " included
1
2
Outer
flange
Inner
flange
Auxiliary handle
assembling orifice
Clamp
lever
Protection Guard Assembly
• Match both cantilevered parts inside the protection guard with the corresponding
slots in the axis cover.
• Turn 180° into the opposite position.
• Fix pushing the clamp lever.
Protective
guard
Disc Assembly
1. Fit the inner flange onto the axis.
2. Set the disc onto the inner flange.
3. Set the outer flange onto the axis.
• Press the axis lock into the grinder head.
4. Screw the outer flange with the two-point spanner wrench until securely fastened.
DANGER The axis lock should only be used to change discs.
Never use the wrench to stop the disc while rotating.
6
ENGLISH
Protective
guard
Auxiliary
handle
Abrasive disc
4

Assembly

Slot
Handle
Switch
/ " included
1
2
Switch
Protective
guard

Parts

Two-pin spanner wrench
(Included)
Power
supply cable
Two-pin
spanner
wrench
3
2
Disc
Inner
flange
5/8-11
UNC-1A
Grinder
head
Axis
lock
Protective
guard
Vent
slots
4
Outer
flange
1